Disassembling the LCD Module

  1. Remove the four LCD screw caps.
  2. Then remove the six screws fastening the LCD bezel.
  3. Remove one screw holding the LCD support on one side.
Acer C200 Travelmate
  1. Remove another screw holding the LCD support on the other side as shown.
  2. Open the cover as shown.
  3. Open the other cover protecting antenna set as shown then remove the LCD support.
  1. Detach the LCD bezel from the LCD module carefully.
  2. Remove the four screws fastening the LCD assembly.
  3. Remove the two screws fastening the finger board.
  1. Turn over the finger board and disconnect the cable then remove the finger board.
  2. Remove the two screws fastening the power board.
  3. Lift the LCD as shown to take out the power board.
  1. Turn over the power board and disconnect the cable then remove the board.
  2. Remove the two screws fastening the launch board.
  3. Disconnect the launch board cable then remove the launch board.
  1. Disconnect the inverter cable then remove the inverter.
  2. Take out LCD assembly from the LCD panel (The LCD support has been removed in step 3 to step 6).
  3. Disconnect the LCD cable from the LCD then remove the cable.
  1. Remove the three screws fastening the digitizer.
  2. Then detach the digitizer as shown.
0 0

Responses

  • milen
    How to dismount acer travelmate c200?
    7 years ago
  • ralph
    How to replace the graphics card on an acer travelmate C200?
    7 years ago

Post a comment