Removing the Hard Disk Drive Module

  1. See "Removing the Battery Pack" on page 62.
  2. See "Removing the SD dummy card" on page 63.
  3. See "Removing the PC and ExpressCard dummy cards" on page 63.
  4. See "Removing the Lower Cover" on page 64.
  5. Disconnect the hard disk module from the connector by pulling on the mylar tab on the hard disk module.
  6. Disconnect the hard disk module from the connector by pulling on the mylar tab on the hard disk module.
What Mylar Tab Hard Drive

6. Remove the hard disk module.

NOTE: To prevent damage to device, avoid pressing down on it or placing heavy objects on top of it. 7. Remove the four screws (G) as shown.

Step

Size (Quantity)

Color

Torque

1~4

M3 x L4 (4)

Silver

1.8 kgf-cm

  1. Remove the hard disk drive from the bracket.
  2. Remove the hard disk drive from the bracket.

Removing the Optical Drive Module

  1. See "Removing the Battery Pack" on page 62.
  2. Turn the base unit over, then remove the one screw (A) on the bottom side of the unit.

Step

Size (Quantity)

Color

Torque

1

M2.5 x L6 (1)

Black

3.0 kgf-cm

  1. Carefully use a plastic screw driver to eject the optical drive tray.
  2. Carefully use a plastic screw driver to eject the optical drive tray.

4. Pull the optical drive module out from the main unit.

"SJI

Remove the two screws (K) securing the locker bracket and remove the locker bracket from the optical disk drive module.

Step

Size (Quantity)

Color

Torque

1~2

M2 x L3 (2)

Black

1.6 kgf-cm

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

Post a comment