Removing the LCD Module

1.

See

"Removing the Battery Pack" on page 56.

2.

See

"Removing the Expansion Slots Cover" on page 64.

3.

See

"Removing the 3G Board Module" on page 64.

4.

See

"Removing the WLAN Board Module" on page 66.

5.

See

"Removing the Middle Cover" on page 70.

Turn over the system and remove the two screws (C) from the bottom of the left and right hinges.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L6 (2)

Black

3.0 kgf-cm

  1. Remove the tape holding the antenna cables in place.
  2. Remove the tape holding the antenna cables in place.

8. Carefully pull out the wireless antenna cables from the hole and release the cables from the latches.

Disconnect the LCD cable connector from the main board.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L6 (2)

Black

3.0 kgf-cm

  1. Carefully remove the LCD module from the base unit.
  2. Carefully remove the LCD module from the base unit.

NOTE: When connecting the cable back to the unit, please note that the cable should be routed well.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment