Removing the LCD Module

  1. See "Removing the Battery Pack" on page 60.
  2. See "Removing the Lower Cover" on page 62.
  3. See "Removing the WLAN Board Modules" on page 64.
  4. See "Removing the Middle Cover and the Power Board" on page 74.
  5. See "Removing the Keyboard" on page 76.
  6. Remove the acetic tape and disconnect the LCD coaxial cable from the LCD1 connector on the main board and release it from the latch.
7. Remove the internal microphone cable from the INTMIC1 connector on the main board.

8. Release the wireless LAN antenna cables from the hole and latches as shown.

9. Remove the two screws (A) from the base of the unit.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L6 (2)

Black

4.0 kgf-cm

  1. Remove the two screws (H) from the left and right hinge of the LCD module.
  2. Remove the two screws (H) from the left and right hinge of the LCD module.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L8 (2)

Black

4.0 kgf-cm

  1. Carefully remove the LCD module from the base unit.
  2. Carefully remove the LCD module from the base unit.

NOTE: When connecting the cable back to the unit, please note that the cable should be routed well.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment