Power Management

The Power Management screen contains parameters that are related to power-saving and power management.

Power Management

Page 1/1

Advanced Power Management Mode

System Hibernate After Standby—

  • Enabled]
  • 2 Min ]
  • 3 Min]
  • 5 Min]
  • 5 Min]

Time---------------------------------

  • Disabled]
  • 04/28/98]
  • 12:00:00]

Sleep Upon Battery-low---------------

  • Enabled]
  • Enabled]

T-l = Move highlight bar, <—> = Change setting, F1 = Help

The following table describes the parameters in this screen. Settings in boldface are the default and suggested parameter settings.

Parameter

Description

Advanced Power

Manage-ment Mode

Enables or disables advanced power management (Windows 95 only). See "Power Management" for more information on power management modes. Options: Enabled or Disabled

Turn Off Display

Will blank the display screen after a set amount of inactivity time on the user input devices. This timer will reset when activity occurs on any keyboard, or pointing device. Options: Never, 1, 2, 3, 5, 10 or 15 Minutes

Turn Off Hard Disk

Will "spin down" the hard disk after a set amount of inactivity on the disk interface. This timer will reset when activity occurs on any primary disk interface, or secondary disk interface. Options: Never, 1, 2, 3, 5,10, 15, 20, 25 or 30 Minutes

System Standby

The system will enter into System Standby mode after a set amout of inactivity time. The timer will be reset once there is activity in any of the following devices: keyboard, pointing devices, communication port, floppy and hard disk drives and bus master requests.

Options: Never, 1, 2, 3, 5, 10, 15, 20, 25, 30, 45 or 60 Minutes

System Hibernation After Standby

The system will enter into Hibernation mode after a set amout of inactivity of time. Timer will be reset once there are activity in the following devices: Keyboard, pointing devices, communication port, floppy and hard disks drive and bus master requests. Options: Never, 1, 2, 3, 5 , 10, 15, 20, 25, 30, 45 or 60 Minutes

Parameter

Resume

Timer

When enabled and the system resume date and time are valid, the computer resumes (wakes up) at the set time and date. Options: Disabled or Enabled

Date

Sets the date the computer resumes at if System Resume Timer is enabled.

Format: month/day/year

Time

Sets the time the computer resumes at if System Resume Timer is enabled.

Format: hour/minute/second

Battery-low

Warning

Beep

When enabled the system emits an audible warning beep when the unit is running low on battery. Options: Enabled or Disabled

Sleep Upon Battery-low

When enabled the system switches into Sleep mode when the unit is running low on battery. Options: Enabled or Disabled

0 0

Post a comment