Running PQA Diagnostics Program

Press to move around the main menu. Press Enter to enable the selected option. The main options are Diag, Result, SysInfo, Option and Exit.

The Diag option lets you select testing items and times.

The following screen appears when you select Diag from the main menu.

One Test Performs a single test and manual checks the selected test items in sequence. Multi Test Performs multiple tests and manual checks the selected test items in sequence. Full Test Performs all items and full check the all test items in sequence.

Quick Test Performs special tests of the highlighted items and quickly check the selected test items in sequence.

The screen below appears if you select Multi Test.

PQA Vx_x xx-xx-xx

PQA Vx_x xx-xx-xx

Specify the desired number of tests and press Enter.

After you specify the number of tests to perform, the screen shows a list of test items (see below):

Vx x

Test Items ] S ystem Board ] Memory ] Keyboard ] Video ] Parallel Port ] Serial Port ] Diskette Drive ] Hard Disk ] CD-ROM ] Coprocessor ] Pointing Dev. ] Cache

Test Items ] S ystem Board ] Memory ] Keyboard ] Video ] Parallel Port ] Serial Port ] Diskette Drive ] Hard Disk ] CD-ROM ] Coprocessor ] Pointing Dev. ] Cache

SPACE: mark/unmark selecting item ESC : return to upper menu

F2 : test the marked item(s) ENTER: open subitem's menu Test Times = 1_

xx-xx-xx

Move the highlight bar from one item to another. Press a space to mark or unmark the item. Press Enter to open the subitem menu. Press Esc to close the submenu.

The right corner screen information gives you the available function keys and the specified test number.

  • Space: mark/unmark selecting item ESC: return to upper menu
  • F1: help menu

F2: tests the marked item(s)

  • Enter: Open subitem's menu
  • Test Times: Indicates the number of tests to perform

NOTE: The F1 and F2 keys function only after you finish configuring the Test option.

NOTE: If there are any problems occured during BIOS updated, refer to "Index of PQA Diagnostic Error Code, Message" on page 70 for troubleshooting.

0 0

Post a comment