Removing the LCD with Brackets

1.

See

'Removing the

Battery Pack" on page 51.

2.

See

'Removing the

SD Dummy Card" on page 51.

3.

See

'Removing the

Express Dummy Card" on page 52

4.

See

'Removing the

Lower Cover" on page 53.

5.

See

'Removing the

Fan Module" on page 60.

6.

See

'Removing the

CPU Heatsink Module" on page 61

7.

See

'Removing the

CPU" on page 62.

8.

See

'Removing the

Middle Cover" on page 64.

9.

See

'Removing the

Keyboard" on page 65.

10.

See

'Removing the

LCD Module" on page 66.

11.

See

'Removing the

LCD Bezel" on page 82.

  1. See "Removing the Inverter Board" on page 83.
  2. Detach the CCD board cable from the CCD board, then remove the board.

14. Remove the two screws (I) securing the left and right LCD brackets to the LCD back cover.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L5 (2)

Silver

2.5 kgf-cm

  1. Carefully detach the cables from the latches on the LCD bracket as shown.
  2. Carefully detach the cables from the latches on the LCD bracket as shown.

16. Detach the LCD with the brackets from the back cover.

Cover Bezel Lcd Cmos

17. Turn the LCD panel over, then detach the acetic tapes holding the FPC cable to the edge of the LCD panel and detach the acetic tape securing the FPC connector.

18. Disconnect the FPC cable from the LCD panel.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment