Removing the WLAN Module

  1. See "Removing the Battery Pack" on page 46.
  2. Remove the WLAN cover. See "Removing the Lower Covers" on page 49.
  3. Remove the adhesive tape and disconnect the antenna cables from the WLAN board.
Quelle Couleur Choisir Avec Gris
4. Move the antenna cables away and remove the two screws on the WLAN board to release the WLAN board.

Step

Size

Quantity

Screw Type

WLAN Module

M2*3 (NL)

2

5. Detach the WLAN board from the WLAN socket.

NOTE: When re-attaching the antenna cables, ensure the black cable is attached to connector -1, while the white cable is attached to connector-2.

  1. See "Removing the Battery Pack" on page 46.
  2. Remove the HDD cover, See "Removing the Lower Covers" on page 49.
  3. Use the mylar tab to slide and lift up the hard disk drive module to remove.

NOTE: To prevent damage to device, avoid pressing down on it or placing heavy objects on top of it. 4. Remove the HDD holder by easing the sides outward to clear the carrier.

Remove the four screws securing the hard disk to the carrier.

Step

Size

Quantity

Screw Type

HDD Carrier

M3*3.5 (NL)

4

  1. Remove the HDD from the carrier.
  2. Remove the HDD from the carrier.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

Post a comment