LCD Module Reassembly Procedure Replacing the LCD Panel

  1. Align the LCD brackets with the eight screw holes (four on each side) on the LCD Panel as shown.
  2. Align the LCD brackets with the eight screw holes (four on each side) on the LCD Panel as shown.
2. Secure the LCD brackets to the LCD panel.
3. Turn the panel over. Insert the LCD Panel cable into the LCD Panel as shown.

4. Replace the MIC cable under the mylar tab strips, and replace the MIC as shown. Secure the cable by pressing down on the strips.

  1. Replace the antenna cables and assembly.
  2. Replace the tabs securing the left and right antennas to the LCD module.
  3. Replace the strips holding the antenna cables in place. Ensure the cables are free from obstructions.
  4. Replace the strips holding the antenna cables in place. Ensure the cables are free from obstructions.

8. Secure the cable by pressing down on the securing strip.

Replace the two securing screws on the LCD Module.

10. Replace the camera board in the bracket. 11. Replace the securing screw on the camera board.

12. Replace the Camera Module in the bottom cover. 13. Press the module in place and replace the securing screw on the Camera Module bracket.

  1. Connect the Camera Module cable as shown.
  2. Connect the left and right Inverter board cables as shown.
16. Connect the left and right Inverter board cables as shown.
17. Press the inverter board in place to secure.
Reassembling The Lcd Module
18. Replace the securing tapes from the left and right sides of the Inverter board as shown.
NOTE: Tuck the cables securely to prevent damage to the cables or module.

Was this article helpful?

0 0

Post a comment