Removing the LCD Module

  1. See "Removing the Battery" on page 56.
  2. See "Removing the Middle Cover" on page 60.
  3. See "Removing the Keyboard" on page 60.
  4. Disconnect the inverter cable with a flat headed screw driver.
  5. Take out the LVDS cable then disconnect the LVDS cable.
  6. Tear off the tape securing the wireless LAN antennae then release the antennae.
  1. Remove the two screws securing the LCD module on the rear side.
  2. Remove the two screws securing the LCD module on the bottom.
  3. Then detach the LCD module carefully.

Was this article helpful?

0 0

Post a comment