Disassembling the LCD Module

  1. Remove the eight LCD rubber caps as the picture shows.
  2. Then remove the eight screws holding the LCD bezel.
  1. Remove the three screws on one side.
  2. Remove another three screws on the other side.
  3. Then detach the LCD bezel carefully.
  1. Remove one screw holding the LCD bracket on one side.
  2. Remove another screw holding the LCD bracket on the other side.
  3. Then remove the entire LCD from the LCD panel.
  1. Disconnect the LCD FPC cable from the inverter board.
  2. Disconnect the high voltage cable from the inverter board.
  3. Then take out the inverter board.
  1. Remove the two screws holding the left LCD bracket.
  2. Remove the left LCD bracket.
  1. Remove the two screws holding the right LCD bracket.
  2. Remove the right LCD bracket.

Was this article helpful?

0 0

Post a comment