Startup Configuration

The Startup Configuration sub-menu contains parameter values that define how your computer behaves on system startup.

Startup Configuration

Page 1/1

Hotkey Beep -----------------

  • Auto]
  • Disabled]
  • Enabled ]

PnPOS-------------------

  • Disabled]
  • Enabled ]
  • Enabled]

3rd-----------------------

  • Floppy Disk]
  • Hard Disk]
  • CD-ROM]

TJ. = Move highlight bar, <-

-ยป = Change setting, F1 = Help

The following table describes the parameters in this sub-menu. Settings in boldface are the default and suggested parameter settings.

Parameter

Description

Options

Boot Display

Sets the display on boot-up. When set to Auto, the computer automatically determines the display device when the computer starts up. If an external display device (e.g., monitor) is connected, it becomes the boot display; otherwise, the computer LCD is the boot display. When set to Both, the computer outputs to both the computer LCD and an external display device if one is connected.

Auto or Both

USB Function Support

Enables or disables the Universal Serial Bus (USB) port.

Disabled or

Enabled

Hotkey Beep

Enables or disables a system beep when a hotkey or key combination is pressed.

Enabled or

Disabled

ACPI OS Fast Post

ACPI OS Fast Post allows your computer to boot up and resume from Standby/ Hibernation/Sleep mode faster. When enabled, allows the operating system (with ACPI) and BIOS to communicate information about Plug-and-Play resources and previous boot-ups.

Disabled or

Enabled

Parameter

Description

Options

Quiet Boot

Hides the POST messages and displays the TravelMate logo startup screen.

Enabled or

Disabled

PnP OS

With Simple Boot FLAG disabled, enables or disables Plug-and-Play operating system settings.

Enabled or

Disabled

Boot Drive Sequence

Specifies the order in which the computer starts up from. See the section below.

1st: Floppy Disk, 2nd: Hard Disk, 3rd: CD-ROM

0 0

Post a comment