Removing the LCD Module

  1. Detach the middle cover from the main uiit carefully.
  2. Disconnect the launch board FFC from the launch board.
  1. Remove the middle cover (with launch board and microphone) from the main unit.
  2. Disconnect the microphone cable from the launch board.
  1. Take out the microphone from the middle cover.
  2. Remove the two screws fastening the launch board.
  3. Then remove the launch board from the middle cover.
  1. Remove the screw holding the keyboard.
  2. Turn over the keyboard as shown.
  3. Disconnect the keyboard cable.
  1. Remove the keyboard from the main unit.
  2. Tear off the tapes fastening the wireless antenna cable.
  1. Pull the antenna set from the main unit.
  2. Disconnect the LCD cable.
  3. Turn over the notebook then remove two screws fastening the LCD module.



. .,.

- ยง


. r*

  1. Remove two screws fastening the LCD hinges.
  2. Then detach the LCD module from the main unit.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment