Disassembling the LCD Module with video camera

  1. Remove the four screw caps as shown.
  2. Remove the four screws holding the LCD bezel.
  3. Then detach the LCD bezel from the LCD module.
  1. Remove the two screws fastening the LCD inverter.
  2. Take out the LCD inverter from the LCD cover, then disconnect the LCD cable from the inverter.
  3. Remove the two screws holding the digital camera to the LCD panel.
  1. Detach the CCD panel from the CCD bezel assembly.
  2. Disconnect digital camera to LCD cable as shown.
  3. Remove the two screws fastening the CCD.
  1. Take out the CCD from the CCD bezel.
  2. Then remove the CCD hinge from the CCD bezel.
  3. Slide the CCD latch to the right to remove the CCD latch.

NOTE: The edges of the CCD latch is very fragile, please practice this step very carefully.

  1. Take out the LCD assembly from the LCD panel.
  2. Disconnect the LCD cable from the LCD.
  3. Tear off the tape fastening the LCD cable and detach the LCD cable from the LCD.
  1. Remove the two screws holding the wireless antenna set to the LCD panel.
  2. Take out the wireless antenna set from the LCD panel.
  3. Remove the two screws holding the LCD hinges then remove the hinges.
  1. Remove the four screws fastening the LCD right bracket.
  2. Remove the right bracket from the LCD.
  1. Remove the four screws fastening the LCD left bracket.
  2. Remove the left bracket from the LCD.
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment