Changing a Password

1. Use the g and g keys to highlight the Set Supervisor Password parameter and press the key. The Set Password box appears:

Set Supervisor Password

Enter current p as swo rd [


Enter New Password [


Confirm New Password [


  1. Type the current password in the Enter Current Password field and press .
  2. Type a password in the Enter New Password field. Retype the password in the Confirm New Password field.
  3. Press . After setting the password, the computer sets the User Password parameter to "Set".
  4. If desired, you can enable the Password on boot parameter.
  5. When you are done, press g to save the changes and exit the BIOS Setup Utility.

If the verification is OK, the screen will display as following. The password setting is complete after the user presses g.

If the current password entered does not match the actual current password, the screen will show you the Setup Warning.

If the new password and confirm new password strings do not match, the screen will display the following message.

Setup Warning Password do not match Re-enter Password

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment