Removing theTouch Pad Board Module

1.

See

"Removing the Battery Pack" on page 60.

2.

See

"Removing the SD dummy card" on page 60.

3.

See

'Removing the ExpressCard dummy card" on page 61.

4.

See

"Removing the Lower Cover" on page 61.

5.

See

"Removing the DIMM" on page 62.

6.

See

"Removing the WLAN Board Modules" on page 63.

7.

See

"Removing the Hard Disk Drive Module" on page 64.

8.

See

"Removing the Keyboard" on page 67.

9.

See

"Removing the Middle Cover" on page 68.

10.

See

"Removing the LCD Module" on page 70.

11.

See

"Separating the Upper Case from the Lower Case" on page 74

12.

See

"Removing the Button Board" on page 76.

13.

See

"Removing the Fingerprint Board Module" on page 80.

14.

Carefully pry loose and remove the touch pad board.

Dimm Password Pads

WARNING:The touchpad board is glued to the upper case, only remove the touchpad board if it is defective.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment