Removing the LCD Module

  1. See "Removing the Battery Pack" on page 60.
  2. See "Removing the Lower Cover" on page 61.
  3. See "Removing the WLAN Board Modules" on page 63.
  4. See "Removing the Keyboard" on page 67.
  5. Remove the two screws (F) from the left hinge cover and carefully pry loose and remove the left hinge cover.
Hinges Acer Ferrari 1100

Step

Size (Quantity)

Color

Torque

1~2

M2 x L4 (2)

Black

1.6 kgf-cm

6. Carefully pry loose the latch on the right hinge cover; close the LCD panel and then pull up the right hinge cover to remove.

Laptop Torque Hinges

8. Remove the large adhesive tape by the battery bay area and carefully pull the wireless antenna cables throught the routing hole.

Battery Notebook 4332 Diagram

9. Disconnect the LCD cable connector from the main board.

10. Remove the four screws (A) from the left and right hinge of the LCD module.
8930g Left Hinge Cover

Step

Size (Quantity)

Color

Torque

1~4

M2.5 x L6 (4)

Black

4.0 kgf-cm

  1. Carefully remove the LCD module from the base unit.
  2. Carefully remove the LCD module from the base unit.
Laptop Torque Hinges

NOTE: When connecting the cable back to the unit, please note that the cable should be routed well.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment