Removing the CPU and VGA Heatsink Module

  1. See "Removing the Battery Pack" on page 60.
  2. See "Removing the SD dummy card" on page 60.
  3. See "Removing the ExpressCard dummy card" on page 61.
  4. See "Removing the Lower Cover" on page 61.
  5. See "Removing the DIMM" on page 62.
  6. See "Removing the WLAN Board Modules" on page 63.
  7. See "Removing the Hard Disk Drive Module" on page 64.
  8. See "Removing the Keyboard" on page 67.
  9. See "Removing the Middle Cover" on page 68.
  10. See "Removing the LCD Module" on page 70.
  11. See "Separating the Upper Case from the Lower Case" on page 74.
  12. See "Removing the Main Board" on page 85.
  13. Disconnect the heatsink fan connector from the main board.
Acer 1520 Remove Vga Board

14. Remove the four screws (E) securing the CPU and VGA heatsink module in place.


Size (Quantity)




M2 x L4 (4)


1.6 kgf-cm

15. Carefully lift up the heatsink module.

Acer Ferrari 1100

Was this article helpful?

+3 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


  • Negisti
    How to remove connectors board?
    9 years ago

Post a comment