Removing Replacing the MPB Battery

To remove and replace an MPB battery pack or dummy battery pack, use the following procedure:

  1. Turn off the computer; disconnect the AC power adapter (if it is attached), and remove the battery pack and PCMCIA cards as described in Paragraphs 6.5.1 and 6.5.2. Also disconnect the MPB (Paragraph 6.5.3) if attached.
  2. Using your thumbs, unlock the two battery locks at each side of the MPB (refer to Figure 6-26).
  3. Pull the module out of the MPB.
  4. Installation is the reverse of Steps 1 through 3.
Battery Groove

Removing the Battery

Figure 6-26 Installing/Removing Battery Pack in MPB

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment