Removing Replacing the Top Cover

Use the following procedure to detach the top cover from the Base Assembly:

  1. Separate the Display Assembly from the Base Assembly as described in Paragraph 6.5.9.
  2. Remove the two screws that secure the heat sink to the base assembly.
  3. Remove the two screws on the top and ten screws on the bottom that hold the top cover in place; unsnap and remove the top cover (refer to Figure 6-15).

Replacement of the top cover is the reverse of Steps 1 through 3.

Remove two screws near display hinge screw holes

Remove two screws near display hinge screw holes

  • 2) Remove 10 screws from bottom of unit (2 circled screws are shorter)
  • 3) Unsnap and remove the top cover
  • 2) Remove 10 screws from bottom of unit (2 circled screws are shorter)

Note: The 65x Series Notebooks contain 9 screws (3 are shorter than the rest)

(3) Unsnap and remove the top cover

Note: The 65x Series Notebooks contain 9 screws (3 are shorter than the rest)

Figure 6-15 Removing/Replacing the Top Cover

Was this article helpful?

0 0
The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment