Removing Replacing the Notebook Battery Pack

Battery Reconditioning 4 You

How to Recondition a Battery

Get Instant Access

Before performing any of the assembly/disassembly procedures, always disconnect the AC adapter from the notebook and remove the battery pack. The procedure for removing and replacing the battery pack is as follows:

  1. Turn off the computer and disconnect the AC adapter from the computer.
  2. Unlatch the battery compartment door (right front corner of the unit) as shown in Figure 6-2.
  3. Slide the battery compartment door out slightly and then swing the door outwards as shown in Figure 6-2.
  4. Grasp the loop attached to the battery and pull the battery out of the compartment.
  5. Insert the replacement battery with "THIS SIDE UP" label facing upwards until it snaps in place and then close the battery compartment door (reverse of Steps 2 and 3.

Figure 6-2. Battery Removal/Replacement

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment