Chapter

This chapter contains step-by-step procedures on how to disassemble the notebook computer for maintenance and troubleshooting.

To disassemble the computer, you need the following tools:

  • Wrist grounding strap and conductive mat for preventing electrostatic discharge
  • Plastic flat head screw driver
  • Plastic tweezers
  • Philips screw driver
  • Any plastic tool can take off the middle cover

NOTE: The screws for the different components vary in size. During the disassembly process, group the screws with the corresponding components to avoid mismatch when putting back the components. When you remove the stripe cover, please be careful not to scrape the cover.

NOTE: Please pay special attention to TravelMate 290 (system part number will be LX.T44...) keyboard. This model is with VGA board, the keyboard needs to have the gasket on its back. Please do NOT use TravelMate 290/TravelMate 290E (system part mumber will be LX.T35.../LX.T40...) keyboard as substitute. The image below is keyboard with gasket on its back employed for this model.

Acer Extensa 2900

Was this article helpful?

0 0

Post a comment