1. Remove the protective covering on the left and right Antenna pads. Place the Antenna pads in the LCD Module and press down to secure the adhesive in place.
2. Run the left side cable down the side and along the lower edge of the LCD Module using all the available cable clips.
NOTE: The LCD Module appears as shown when the Antennas are replaced correctly. Ensure that the Antennas run through the hinge well as shown to avoid trapping when the LCD Panel is replaced.
IMPORTANT: If the LCD Panel is replaced, remove the protective strips from the defective panel and reuse them on the replacement panel as shown.
NOTE: The vertical strip shown in the first image may appear on the right of the panel for some models.
1. Insert the LCD Cable into the panel connector as 2. Secure the connector by replacing the adhesive strip shown. as shown. Press down to secure the adhesive.
Replace the LCD Panel top edge first as shown. Lower the Panel in to the LCD Module, ensuring the LCD cables are not trapped between the panel and the casing.
4. Replace the two securing screws.
Was this article helpful?
Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.