Replacing the LCD Module

1. Place the LCD Module on the Lower Cover and secure it in place with the two screws.

2. Connect the Power cable to the Mainboard and secure the cable in place with the adhesive tape.

3. Pass the Antenna cables through the Lower Cover as shown.

NOTE: The yellow and blue cables are only present on the 3G models.

4. The Lower Cover appears as follows when all the LCD cables are correctly placed.
1. Insert the FFC in to the TouchPad connector. 2. Close the locking latch to secure the cable in place.
Reconnect Touchpad Connector
  1. Place the Button Board rear edge first on to the Upper Cover to engage the securing clips.
  2. Replace the two securing screws.
  3. Replace the two securing screws.
3. Insert the TouchPad FFC in to the Button Board connector and close the locking latch.

4. Lift the plastic covering and insert the FFC so that it 5. Secure the FFC in place with the adhesive strip. is accessible from the top side.

6. Insert the FFC in to the Button Board and close the locking latch.
Touchpad Button Board Clip

Was this article helpful?

0 0
The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment