Disassembling the LCD Module

  1. Remove the four screw caps as shown.
  2. Remove the four screws holding the LCD bezel.
  3. Then detach the LCD bezel from the LCD module.
  1. Remove the four screws fastening the LCD and the LCD inverter to the panel.
  2. Place the LCD as shown.
  3. Disconnect the LCD back light cable.
  1. Disconnect the LCD cable on the other side, then remove the inverter.
  2. Take out the LCD assembly from the LCD panel.
  3. Tear off the tape fastening the LCD cable then disconnect the LCD cable and remove it.
  1. Remove the four screws fastening the LCD left bracket and remove it.
  2. Remove the four screws holding the LCD right bracket and remove it.
  3. Remove the two screws holding the wireless antenna set to the LCD panel then remove the antenna set. NOTE: The antenna set is fastening to the LCD panel with foil, please release the foil covering the antenna set before you detach the antenna set.
  1. Take out the spring carefully.
  2. Remove the LCD latch from the LCD panel.
  3. Release the foil fasteing the CCD module cable.
  1. Remove the screw holding the CCD module to the LCD panel then detach the CCD module.
  2. Separate the CCD panel from the CCD assembly.
  3. Then remove the two screws fastening the digital camera to CCD hinge and CCD panel.
  1. Take out the CCD hinge.
  2. Take out the digital camera board from the CCD panel.
  3. Disconnect the cable from the digital camera board.

Was this article helpful?

0 0

Post a comment