Standard Bezel LCD Module ReassemblyLCD Panel

1. Connect the LCD cable to the panel connector as 2. Press down the adhesive strip to secure the cable shown. in place.

3. Run the cable along the back of the panel and press down as indicated to secure the cable in place.

IMPORTANT: Ensure that the LCD cable runs between the green callouts to avoid trapping when the panel is replaced in the LCD Module.

4. Align the LCD brackets with the screw holes on the panel. Replace the eight (8) screws (four on each side) in the brackets as shown.

  1. Align the Camera Board with the locating pins on the LCD Module and place the board as shown.
  2. Press down as shown to secure the board in place with adhesive.

7. Place the LCD Panel adjacent to the LCD Module as shown and connect the Camera cable to the Camera Module.

8. Flip the LCD Panel over and place it in the LCD Module. IMPORTANT: Ensure that the LCD cable is not trapped under the panel.

NOTE: The six (6) bracket screws are numbered from 1 to 3 on each bracket. Replace the screws in order from 1 to 3.

1. Place the LCD Bezel adjacent to the LCD Module as shown and connect the Microphone cable.
2. Flip the LCD Panel over and place it in the LCD Module.

IMPORTANT: Ensure that the LCD cables are not trapped in the hinge wells.

3. Press down around the perimeter of the bezel to secure it in place.

4. Replace the four (4) screws securing the bezel to the LCD Module.

IMPORTANT: The Standard Bezel is secured with two (2) different screw types: M2.5*4—red callout and M2.5*5—green callout. Ensure that the correct screws are used during reassembly.

1. Connect the LCD cable to the panel connector as 2. Press down the adhesive strip to secure the cable shown. in place.

3. Run the cable along the back of the panel and press down as indicated to secure the cable in place.

IMPORTANT: Ensure that the LCD cable runs between the green callouts to avoid trapping when the panel is replaced in the LCD Module.

4. Align the LCD brackets with the screw holes on the panel. Replace the eight (8) screws (four on each side) in the brackets as shown.

  1. Align the Camera Board with the locating pins on the LCD Module and place the board as shown.
  2. Press down as shown to secure the board in place with adhesive.

7. Place the LCD Panel adjacent to the LCD Module as shown and connect the Camera cable to the Camera Module.

8. Flip the LCD Panel over and place it in the LCD Module. IMPORTANT: Ensure that the LCD cable is not trapped under the panel.

9. Run the LVDS and Antenna cables through the hinge wells as shown.
10. Secure the LCD module with nine (9) securing screws.

NOTE: The six (6) bracket screws are numbered from 1 to 3 on each bracket. Replace the screws in order from 1 to 3.

The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment