Removing the LCD Module

See See See See See See See See See

10. See

11. See

Removing the SD Dummy Card" on page 44. Removing the Battery Pack" on page 45. Removing the Back Cover" on page 46. Removing the Hard Disk Drive Module" on page 48. Removing the Wireless LAN Card" on page 50. Removing the DIMM Module" on page 51. Removing the Heatsink Module" on page 52. Removing the CPU" on page 54. Removing the Optical Drive Module" on page 55. Removing the Middle Cover" on page 58. Removing the Keyboard" on page 60.

12. Release the wireless antenna cables from the latches and carefully pull out the wireless antenna cables from the hole..

13. Remove the LCD cable from its connector on the main board and release the cable from the latches.

14. Remove the four screws (D) from the left and right hinges.

Size (Quantity)

Color

Torque

Part No.

M2.5 x L10 (4)

Black

3.0 kgf-cm

86.00F84.73A

15. Carefully remove the LCD module from the base unit.

NOTE: When connecting the cables back to the unit, please note that the cables should be routed well.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment