Removing the Fingerprint Button and Touchpad Boards

  1. See "Removing the Battery Pack" on page 44.
  2. See "Removing the SD Dummy Card" on page 45.
  3. See "Removing the Hard Disk Drive 2 (HDD2) Module" on page 46.
  4. See "Removing the Back Cover" on page 48.
  5. See "Removing the Hard Disk Drive 1 (HDD1) Module" on page 48.
  6. See "Removing the TV Tuner Card (for certain models only)" on page 50.
  7. See "Removing the Wireless LAN Card" on page 52.
  8. See "Removing the DIMM Module" on page 53.
  9. See "Removing the Optical Drive Module" on page 54.
  10. See "Removing the Middle Cover" on page 57.
  11. See "Removing the Keyboard" on page 60.
  12. See "Removing the LCD Module" on page 61.
  13. See "Separating the Upper Case from the Lower Case" on page 64.
  14. Remove the four screws (F) securing the touchpad and fingerprint/button bracket to the upper case.

Size (Quantity)



Part No.

M2 x L4 (4)


1.6 kgf-cm


15. Release the latch (a) and disconnect the touchpad cable (b) from the touchpad board. Release the latch (c) and disconnect the fingerprint/ button cable (d) from the fingerprint/ button board.

Acer Aspire 7535g

18. Pry to loosen the touchpad board.

Acer Aspire 7735 Touchpad

WARNING: The touchpad board is glued to the upper case, only remove the touchpad board if it is defective. 19. Detach the touchpad board from the upper case.

Note: Circuit boards > 10cm2 has been highlighted with the yellow square as shown in the figure above. Please detach the circuit boards and follow the local regulations for disposal.

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment