Removing the Power Board

  1. See "Removing the Battery Pack" on page 44.
  2. Expose the bottom side of the Switch Cover. See "Removing the Switch Cover" on page 60.
  3. Unlock the connector to remove the FFC cable.
Aspire 6530 Power Board

4. Grasp the cable and disconnect from the Power Board.

5. Remove the three securing screws from the Power Board.

Step

Size

Quantity

Screw Type

Power Board

M2.0*3.0-I (BKAG) (NYLOK) IRON

3

  1. Hold the module by the sides and lift to remove.
  2. Hold the module by the sides and lift to remove.
  1. Remove the Switch Cover. See "Removing the Switch Cover" on page 60.
  2. Lift and turn the keyboard over (as shown) to expose the FFC.
3. Unlock the connector and pull the FFC to remove.
  1. Remove the keyboard from the chassis.
  2. Remove the Keyboard. See "Removing the Keyboard" on page 63.
  3. Remove the three securing screws (red in the following image) from the Subwoofer Module.
  4. Remove the two securing screws (blue in the following image) the Speaker Module.

Step

Size

Quantity

Screw Type

Subwoofer Module (red callout)

M3*3

(not available for order)

3

Speaker Module (blue callout)

M2.5*4.0-I (NI)(NYLOK)

2

ยป

  1. Disconnect the speaker cable as shown.
  2. Disconnect the speaker cable as shown.
5. Grasp the Subwoofer Module from the RIGHT side as shown and tilt over and to the left, as shown.
NOTE: The Subwoofer Module is not a replacable part. Do NOT remove from the computer.

6. Grasp the Speaker Module by the right side and tilt up to remove.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment