Removing the Hard Disk Drive Module

  1. See "Removing the Lower Covers" on page 47.
  2. Use the pull-tab to lift the HDD and disconnect the interface.

3. Lift the hard disk drive module out of the bay.

NOTE: To prevent damage to device, avoid pressing down on it or placing heavy objects on top of it.

4. Remove the vertical interface connector as shown.

  1. Remove the four screws (two each side) securing the hard disk to the carrier.
  2. Remove the four screws (two each side) securing the hard disk to the carrier.

Step

Size

Quantity

Screw Type

HDD Carrier

M3*3

4

Was this article helpful?

0 0

Post a comment