Removing the Upper Base

  1. See "Removing the LCD Module" on page 68.
  2. Turn the computer over. Remove the nine screws on the bottom panel.

Step

Size

Quantity

Screw Type

Upper Cover

M2.5*6

9

*

  1. Turn the computer over. Remove the 13 securing screws on the top panel.
  2. Turn the computer over. Remove the 13 securing screws on the top panel.

Step

Size

Quantity

Screw Type

Upper Cover (red callout)

M2.5*6

13

*

4. Turn the computer over and disconnect the four cables from the mainboard.

WARNING:Care must be taken when removing the Upper Base from the Lower Base to prevent damage or stress to the surface.

5. Ease the lower casing outward to clear the securing clips and pry apart the upper left side as shown, and lift the rear edge of the Upper Base upward.

6. Ease the lower casing outward to clear the securing clips and pry apart the right side as shown. Lift the rear edge of the Upper Base upward.

7. Completely remove the Upper Base from the Lower Base.

Was this article helpful?

0 0
The Ultimate Computer Repair Guide

The Ultimate Computer Repair Guide

Read how to maintain and repair any desktop and laptop computer. This Ebook has articles with photos and videos that show detailed step by step pc repair and maintenance procedures. There are many links to online videos that explain how you can build, maintain, speed up, clean, and repair your computer yourself. Put the money that you were going to pay the PC Tech in your own pocket.

Get My Free Ebook


Post a comment