Removing the WLAN Board Modules

  1. See "Removing the Battery Pack" on page 50.
  2. See "Removing the Lower Cover" on page 52.
  3. Remove the white antenna cable that is taped to the WLAN board module.

4. Disconnect the antenna cables from the WLAN board.

NOTE: There are 2 antenna cables connected to the WLAN board module. The Black antenna cable is connected to the MAIN connector and the Gray antenna cable is connected to the AUX connector.

5. Move the antenna away from the WLAN board and remove the one screw (H) on the WLAN board to release the WLAN board.


Size (Quantity)




M2 x L3 (1)


1.6 kgf-cm

6. Detach the WLAN board from the WLAN socket.

NOTE: When attaching the antenna back to the WLAN board, make sure the cable are arranged properly.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook

Post a comment