Removing the LCD Module

1.

See

"Removing the Battery Pack" on page 50.

2.

See

"Removing the SD dummy card" on page 51.

3.

See

"Removing the ExpressCard dummy card" on page 51

4.

See

"Removing the Lower Cover" on page 52.

5.

See

"Removing the WLAN Board Modules" on page 54.

6.

See

"Removing the Middle Cover" on page 62.

7.

See

"Removing the Heatsink Fan Module" on page 64.

8.

See

"Removing the CPU Heatsink Module" on page 65.

9. Turn over the system and remove the two screws (A) from the bottom of the left and right hinges.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L8 (2)

Black

3.0 kgf-cm

  1. Disconnect the LCD cable connector from the main board.
  2. Disconnect the LCD cable connector from the main board.

11. Carefully pull out the wireless antenna cables from the hole and release the cables from the latches.

12. Remove the two screws (E) from the left and right hinge of the LCD module.

Step

Size (Quantity)

Color

Torque

1~2

M2.5 x L10 (2)

Silver

3.0 kgf-cm

13. Carefully remove the LCD module from the base unit.

NOTE: When connecting the cable back to the unit, please note that the cable should be routed well.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment