Memory Check

Memory errors might stop system operations, show error messages on the screen, or hang the system.

  1. Boot from the diagnostics diskette and start the diagnostic program (please refer to main board.
  2. Go to the diagnostic memory in the test items.
  3. Press F2 in the test items.
  4. Follow the instructions in the message window.

NOTE: Make sure that the DIMM is fully installed into the connector. A loose connection can cause an error.

To verify the symptom of the problem, power on the computer using each of the following power sources:

  1. Remove the battery pack.
  2. Connect the power adapter and check that power is supplied.
  3. Disconnect the power adapter and install the charged battery pack; then check that power is supplied by the battery pack.

If you suspect a power problem, see the appropriate power supply check in the following list:

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


  • clare
    How to check memory on acer aspire 6930?
    8 years ago
  • donald
    How to test acer laptop memory?
    8 years ago
  • Rian Simpson
    How to check loose memory of acer aspire ?
    8 years ago

Post a comment