Removing the Touchpad Module

1.

See

'Removing the Battery Pack" on page 44.

2.

See

'Removing the Lower Cover" on page 45.

3.

See

"Removing the Lower Cover" on page 45.

4.

See

"Removing the Optical Drive Module" on page 46.

5.

See

"Removing the DIMM" on page 46.

6.

See

"Removing the Hard Disk Drive Module" on page 47.

7.

See

"Removing the SSD Module" on page 48.

8.

See

"Removing the RTC Battery" on page 49.

9.

See

"Removing the Keyboard" on page 51.

10.

See

"Removing the WLAN Board Module" on page 52.

11.

See

"Separating the Upper Case from the Lower Case" on page 53

12. Disconnect the touchpad cable from the touchpad board; then carefully pry loose and remove the touch pad board

Touchpad Module

WARNING:The touchpad board is glued to the upper case, only remove the touchpad board if it is defective.

Note: Circuit boards >10 cm2 has been highlighted with the yellow rectangle as above image shows. Please detach the Circuit boards and follow local regulations for disposal.

DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Responses

  • cupido romani
    How to fix acer 4810t touch pad?
    7 years ago

Post a comment