Undetermined Problems

The diagnostic problems does not identify which adapter or device failed, which installed devices are incorrect, whether a short circuit is suspected, or whether the system is inoperative.

NOTE: Verify that all attached devices are supported by the computer.

NOTE: Verify that the power supply being used at the time of the failure is operating correctly. (See "Power System Check" on page 93.)

Follow procedures below to isolate the failing FRU. Do not isolate non-defective FRU.

  1. Power off the computer.
  2. Visually check them for damage. If any problems are found, replace the FRU.
  3. Remove or disconnect all of the following devices:
  • Non-Acer devices
  • Printer, mouse, and other external devices
  • Battery pack
  • Hard disk drive

□ DIMM

  • CD/DVD-ROM drive
  • PC cards
  1. Power on the computer.
  2. Determine if the problem has been resolved.
  3. If the problem does not recur, reconnect the removed devices one at a time until you find the failed FRU.
  4. If the problem persists, replace the following FRU one at a time. Do not replace a non-defective FRU.
  • System board
  • LCD assembly

Chapter 5

System Block Diagram and Connector Locations System Block Diagram

Block Diagram Lcd
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment