Disassembly Procedure Flowchard

Unit Flow Chart

The flowchart on the succeeding page gives you a graphic representation on the entire disassembly sequence and instructs you on the components that need to be removed during servicing. For example, if you want to remove the system board, you must first remove the keyboard, then disassemble the inside assembly frame in that order. 2. Slide the battery latch then remove the battery. NOTE Battery has been highlighted with the yellow circle as above image shows. Please detach the battery and follow...

Machine Disassembly and Replacement

This chapter contains step-by-step procedures on how to disassemble the notebook computer Aspire 3810T 3810TG 3810TZ 3810TZG for maintenance and troubleshooting. To disassemble the computer, you need the following tools Wrist grounding strap and conductive mat for preventing electrostatic discharge Plastic flat head screw driver NOTE The screws for the different components vary in size. During the disassembly process, group the screws with the corresponding components to avoid mismatch when...

Index of Error Messages

Equipment Configuration Error Causes 1. CPU BIOS Update Code Mismatch. 2. IDE Primary Channel Master Drive Error. THe causes will be shown before Equipment Configuration Error . Memory Error at xxxx xxxx xxxxh R xxxxh, W xxxxh . In this situation BIOS will issue 4 short beeps then shut down system, no message will show. In this situation BIOS will shut down system, not show message. Reconnect hard disk drive connector. Load Default Settings in BIOS Setup Utility. Hard disk drive System board...

System Check Procedures

Do the following to isolate the problem to a controller, driver, or diskette. A write-enabled, diagnostic diskette is required. NOTE Make sure that the diskette does not have more than one label attached to it. Multiple labels can cause damage to the drive or cause the drive to fail. Do the following to select the test device. 1. Boot from the diagnostics diskette and start the diagnostics program. 2. See if FDD Test is passed as the program runs to FDD Test. 3. Follow the instructions in the...