Disassembling the Lower Case Assembly

  1. Disconnect the MDC cable from the modem board.
  2. Detach the MDC cable from the main board.
  3. Remove the two screws holding the modem board then disconnect the modem board from the main board.
  1. Disconnect the speaker cable from the main board.
  2. Remove the screw that secure the main board.
  1. Remove the two screw nuts as shown.
  2. The you can detach the main board from the upper case.
  3. Remove the ttwo screws that fasten the N/B heatsink.
  1. Remove the N/B heatsink from the main board as shown.
  2. Remove the card reader dummy card from the lower case. (For SKU with three-in-one card reader, please remove three in one cover).
  3. Remove the two screws that secure the speaker set on one side.
  1. Then remove another two screws holding the speaker set on the other side.
  2. Then take out the speaker set from the lower case.

IMPORTANT:When assembling/disassembling the main board, whenever there is a mylar on the main board (see the highlighted with red below; the mylar is sami-transparent, film-like stuff ), it should be transferred "if necessary" to the replacement main board. Because the main board mylar should be stuck to the main board to prevent the antenna cable and the main board components short circuit. The short could cause the main board or the antenna cable burned.

Disassembling the LCD Module

  1. Remove the four screw caps as shown.
  2. Remove the four screws holding the LCD bezel.
  3. Then detach the LCD bezel from the LCD module.
  1. Disconnect the inverter board then remove it.
  2. Remove the three screws holding the right hinge.
  3. Then remove the three screws that secure the left hinge.
  1. Remove one screw that secure the LCD bracket.
  2. Remove another screw holding the LCD bracket on the other side.
  3. Then detach the LCD panel from the LCD cover carefully.
  1. Remove the two screws holding the right bracket.
  2. Then remove the right bracket.
  3. Remove another two screws that tighten the left bracket.
  1. Remove the left bracket as the picture shows.
  2. Tear off the tape fastening the LCD cable.
  3. Tear off the the LCD cable fastening the LCD cable, then remove it..

Disassembling the External Modules

Was this article helpful?

0 0

Post a comment