Removing the Inverter Board LCD

  1. See "Removing the Battery" on page 52.
  2. See "Removing the Middle Cover" on page 56.
  3. See "Removing the Launch Board" on page 56.
  4. See "Removing the LCD Module" on page 57.
  5. See "Removing the LCD Bezel" on page 59.
  6. To remove the inverter board, first remove one screw from the inverter board.

7. Disconnect the LCD power cable then disconnect the inverter cable from the inverter board.

NOTE: Please arrange the LCD inverter cable well to the LCD panel as the picture below shows when you reassemble the LCD module.

Was this article helpful?

0 0

Post a comment