Advanced

The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced settings of the system.

PhoenixBIOS Setup Utility

Information Main

Hyper-Threading Technoloty Infrared Port (FIR): Parallel Port: Mode:

Base I/O address: Interrupt:: DMA channel: Legacy USB Support: Hard Disk Recovery

  • Advanced]
  • Enabled] [Disabled] [Enabled] [ECP] [378] [IRQ 7] [DMA 1] [Disabled] [Enabled]

Security

Item specific Help

Configure Infrared Port using options:

pisabled]

No configuration

  • Enabled] User configuration
  • Auto] BIOS or OS chooses configuration

Select Item Select Menu

(OS Controlled) Displayed when controlled by OS i Change Values Setup defaults

Select ► Sub-Menu Save and Exit

The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings.

Parameter

Description

Options

Hyper-Threading Technology

The function is supported only when the CPU installed is 3.06G or above. The system will automatically hide this selection when detecting the CPU frequency is below 3.06G or the CPU does not support Hyper-Threading Technoloty.

Enabled/Disabled

Infrared Port

Enables, disables or auto detects the infrared port.

Disabled/Disabled/Auto

Parallel Port

Enables, disables or auto detects the parallel port.

Enabled/Disabled/Auto

Mode

Sets the operation mode of the parallel port.

ECP, EPP, Output only or Bidirectional

Base I/O address

Sets the I/O address of the parallel port.

378/278

Interrupt

Sets the interrupt request of the parallel port.

IRQ7/IRQ5

Parameter

Description

Options

DMA channel

Sets a DMA channel for the printer to operate in ECP mode. This parameter is enabled only if Mode is set to ECP.

DMA3/DMA1

Legacy USB Support

Enables, disables USB interface devices support. (Enable for use with a non-USB aware Operating System such as DOS or UNIX).

Option: Disabled or Enabled

Hard Disk Recovery

Enables or disables Hard Disk to Hard Disk system Recovery by pressing Fn+F10 key during POST.

Option: Disabled or Enabled

Was this article helpful?

0 0

Post a comment