Advanced

The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced settings of the system.

PhoenixBIOS Setup Utility

Information Main

Advanced

Security Boot Exit

Parallel port:

[Enabled]

Item Specific Help

Mode:

[Bi-direct]

Base I/O address:

[378]

Interrupt:

[IRQ 7]

Configure Infrared Port

DM A Channel

[DMA3]

using options:

[Auto]

Disable the touchpad if an

external PS/2 mouse is

connected. Otherwise

enable the touchpad

[Both]

The touchpad is always

e nabled. Any external PS/2

mouse connected will be

enabled at the same time.

KHelp ^HH Select Item ^H5/F6 Change Values Exit Select Menu Select 4 Sub-Menu

Setup Defaults Save and Exit

The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings.

Parameter

Description

Options

Serial Port

Enables, disables or auto detects the serial port.

Enabled/Disabled/Auto

Parallel Port

Enables, disables or auto detects the parallel port.

Enabled/Disabled/Auto

Mode

Sets the operation mode of the parallel port.

ECP, EPP, Normal or Bi-directional

Base I/O address

Sets the I/O address of the parallel port. This parameter is enabled only if Mode is set to ECP or Bi-directional. This parameter is enabled only if Mode is set to ECP

378h/278h/3BCH

Interrupt

Sets the interrupt request of the parallel port.

IRQ7/IRQ5

DMA Channel

Sets a DMA channel for the printer to operate in ECP mode. This parameter is enabled only if Mode is set to ECP.

DMA3/DMA1

Parameter

Description

Options

Internal Touchpad

Determines whether or not to disable the internal pointing device as the PS/2 mouse is connected.

Both or Auto

Infrared Port (FIR)

Enables, disables or auto detects the infrared port.

Disabled/EnabledDisabled/Auto

Was this article helpful?

0 0

Post a comment