Index of Error Messages

Battery Reconditioning 4 You

How to Repair Batteries

Get Instant Access

Error Code List

Error Codes

Error Messages

006

Equipment Configuration Error

010

Equipment Configuration Error

070

Real Time Clock Error 1

071

CMOS Battery Bad 4

072

CMOS Checksum Error 1

080

Battery Is Critical Low 1

110

Incorrect password specified, system halted 1

Error Message List

Error Messages

FRU/Action in Sequence

0200 Failure Fixed Disk

Hard disk error detected.

Check to see if fixed disk is attached properly.

Enter the BIOS Setup Utility and verify the hard disk is detected.

0211 Keyboard error

see "Keyboard or Auxiliary Input Device Check" on page 71.

0212 Keyboard Controller Failed

see "Keyboard or Auxiliary Input Device Check" on page 71. May require replacing the keyboard controller.

0213Keyboard locked - Unlock key switch

Unlock the system to proceed.

0220 Monitor type does not match CMOS - Run SETUP

Display device mismatch.

Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer.

0230 Shadow RAM Failed at offset: nnnn

Shadow RAM test failed Main board

0231 System RAM Failed at offset: nnnn

System RAM test failed Main board

0232 Extended RAM Failed at offset: nnnn

Extended RAM test failed Main board

0250 System battery is dead - Replace and run SETUP

CMOS clock battery needs to be replaced. Replace the battery and run BIOS Setup Utility to reconfigure system time, then reboot system.

0251 System CMOS checksum bad - Default configuration used

CMOS has been corrupted or modified incorrectly.

Run BIOS Setup Utility and verify the parameters; then save and restart the computer.

Check the system battery.

0260 System timer error

System timer test fiailed, and the main board needs to be repaired. Run BIOS Setup Utility to reconfigure system time, then reboot system. Main board

0270 Real time clock error

RTC battery

Run BIOS Setup Utility to reconfigure system time, then reboot system.

Main board

0280 Previous boot incomplete - Default configuration used

Previous boot-up was not copleted successfully.

Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer.

RTC battery

Main board

0281 Memory size found by POST differed from CMOS

Run "Load Setup Defaults" in BIOS Setup Utility. Main board

Error Messages

FRU/Action in Sequence

02B0 Diskette drive A/B error

Drive A: or B: is present but fails the BIOS POST diskette tests. Check the drive is defined with the proper diskette type in BIOS

Setup Utility

Check if the diskette drive is attached correctly. See "External Diskette Drive Check" on page 70.

02B2 Incorrect Drive A type - run SETUP

Type of floppy drive A: not correctly identified in Setup. Main board

02D0 System cache error - Cache disabled

RAM cache failed and BIOS disabled the cache.

On older boards, check the cache jummpers. You may have to replace the cache.

Main board

02F0 CPU ID

CPU socket number for Multi-Processor error. Main board

02F4 EISA CMOS not writeable

System unable to write to EISA CMOS. Main board

02F5 DMA Test Failed

System unable to write to DMA (Direct Memory Access) registers. Main board

02F6 Software NMI Failed

System unable to generate software NMI (Non-Maskable Interrupt). Main board

02F7 Fail-Safe Timer NMI Failed

Fail-Safe Timer takes too long. Main board

device Address Conflict

Specific device has an address conflict.

Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer. RTC battery Main board

Failing Bits: nnnn

Memery test failed. DIMM BIOS ROM Main board

Invalid System Configuration Data

Error with NVRAM (CMOS) data.

Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart your computer. Main board

I/O device IRQ conflict

I/O device has IRQ (Interrupt Request) conflict.

Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer.

RTC battery

Main board

Operating system not found

Operating system cannot be found on the boot device.

Enter the BIOS Setup Utility and verify the parameters (try loading the default settings); then save and restart the computer.

Recover hard disk.

Reinstall the operating system.

Parity Check 1 nnnn

Parity error found on system bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays.

Parity Check 2 nnnn

Parity error found on I/O bus. BIOS attempts to locate the address and display it on the screen. If it cannot locate the address, it displays .

No beep Error Messages

FRU/Action in Sequence

No beep, power-on indicator turns off and LCD is blank.

Power source (battery pack and power adapter). See "Power System Check" on page 71.

Ensure every connector is connected tightly and correctly. Reconnect the DIMM. LED board. Main board.

No beep, power-on indicator turns on and LCD is blank.

Power source (battery pack and power adapter). See "Power

System Check" on page 71.

Reconnect the LCD connector

Hard disk drive

LCD inverter ID

LCD cable

LCD Inverter

Main board

No beep, power-on indicator turns on and LCD is blank. But you can see POST on an external CRT.

Reconnect the LCD connectors.

LCD inverter ID

LCD cable

LCD inverter

Main board

No beep, power-on indicator turns on and a blinking cursor shown on LCD during POST.

Ensure every connector is connected tightly and correctly. Main board

No beep during POST but system runs correctly.

Speaker Main board

Was this article helpful?

0 0
DIY Battery Repair

DIY Battery Repair

You can now recondition your old batteries at home and bring them back to 100 percent of their working condition. This guide will enable you to revive All NiCd batteries regardless of brand and battery volt. It will give you the required information on how to re-energize and revive your NiCd batteries through the RVD process, charging method and charging guidelines.

Get My Free Ebook


Post a comment