Advanced

The Advanced menu screen contains parameters involving your hardware devices. It also provides advanced settings of the system.

PhoenixBIOS Setup Utility

Advanced

Security Boot

Base I/O address:

[Enabled]

Item Specific Help

[2F8]

Interrupt:

[IRQ 3]

Configure Infrared Port

DMA channel:

[DMA 1]

using options:

Parallel port:

[Auto]

[Disable]

Mode:

[ECP]

No configuration

Base I/O address:

[378]

Interrupt:

[IRQ 7]

[Enabled]

DMA channel:

[DMA 3]

User configuration

[Auto]

Infrared Port (FIR):

[Enabled]

BIOS or OS chooses

configuration

(OS Controlled)

Displayed when controlled

Select Item Select Menu

Change Values Select 4 Sub-Menu

Setup Defaults Save and Exit

Info.

The table below describes the parameters in the screen. Settings in boldface are the default and suggested parameter settings.

Parameter

Description

Options

Infrared Port

Enables, disables or auto detects the infrared port.

Enabled/Disabled/Auto

Base I/O address

Sets the I/O address of the infrared port.

2F8/3F8/3E8/2E8

Interrupt

Sets the interrupt request of the parallel port.

IRQ3/IRQ4

DMA channel

Sets a DMA channel for the infrared port.

DMA/DMA3

Parallel Port

Enables, disables or auto detects the parallel port.

Enabled/Disabled/Auto

Mode

Sets the operation mode of the parallel port.

ECP, EPP, Output only or Bidirectional

Base I/O address

Sets the I/O address of the parallel port.

378/278

Interrupt

Sets the interrupt request of the parallel port.

IRQ7/IRQ5

Parameter

Description

Options

DMA channel

Sets a DMA channel for the printer to operate in ECP mode. This parameter is enabled only if Mode is set to ECP.

DMA3/DMA1

Legacy USB Support

Enables, disables USB interface devices support. (Enable for use with a non-USB aware Operating System such as DOS or UNIX).

Option: Disabled or Enabled

Was this article helpful?

0 0

Post a comment